No. 9636487

No longer available
Brown's brothers teak wood ships steering wheel
Bidding closed
377 weeks ago

Brown's brothers teak wood ships steering wheel

Wood and brass steering wheel Brown's brothers Edinburgh With eight spokes and brass ring embossed with Brown's Patent Telemotor & Steam Tiller". Rosebank Ironworks Edinburgh Diameter 91 centimeter. In good condition. Most steamships of any size in the 20th Century had a system where the rudder is connected to a ‘steam tiller’ a reciprocating steam engine geared to the rudder post. The most common make of steam steering gear was made by Brown Brothers of Edinburgh. It was used on ships as large as Titanic. The steering engine or steam tiller was duplicated and either set could be engaged or disengaged according to requirements. In the case of the three Olympic Class ships the steering engines were built by Harland & Wolff themselves but Brown Brothers Telemotors were used. The steam tiller was controlled hydraulically with a connection to the wheelhouse by piping and the steering wheel operated two pistons. With the wheel amidships hydraulic pressure was the same in both lines, on turning the wheel to Starboard pressure would be increased in the right hand line and decreased in the left. A censor in the steering flat would open a valve on the steering engine and apply steam until pressure was equalised in the system. If you turned the wheel till the pointer on front of the pedestal was at 5 degrees then the steam tiller would operate until pressure in the lines was equalised and 5 degrees of helm was on. On Titanic there was also an electrically operated helm indicator which sensed the rudder position and relayed this to an indicator on the bridge. The steering wheels on Olympic, Titanic and Britannic were duplicated, the wheel in the forward part of the bridge was only used in port and was connected by shafting to the main Telemotor control and wheel which was in the wheelhouse. The forward wheel could be disconnected by a clutch, which could only be engaged or disengaged when the helm was midships. There was a steering wheel with Telemotor control in docking bridge this was only for emergency use. The Waverley Clyde paddle steamer uses Browns Steam Steering gear and Telemotor. Source: https://www.encyclopedia-titanica.org

No. 9636487

No longer available
Brown's brothers teak wood ships steering wheel

Brown's brothers teak wood ships steering wheel

Wood and brass steering wheel Brown's brothers Edinburgh
With eight spokes and brass ring embossed with Brown's Patent Telemotor & Steam Tiller". Rosebank Ironworks Edinburgh
Diameter 91 centimeter.
In good condition.

Most steamships of any size in the 20th Century had a system where the rudder is connected to a ‘steam tiller’ a reciprocating steam engine geared to the rudder post. The most common make of steam steering gear was made by Brown Brothers of Edinburgh. It was used on ships as large as Titanic. The steering engine or steam tiller was duplicated and either set could be engaged or disengaged according to requirements. In the case of the three Olympic Class ships the steering engines were built by Harland & Wolff themselves but Brown Brothers Telemotors were used.

The steam tiller was controlled hydraulically with a connection to the wheelhouse by piping and the steering wheel operated two pistons. With the wheel amidships hydraulic pressure was the same in both lines, on turning the wheel to Starboard pressure would be increased in the right hand line and decreased in the left. A censor in the steering flat would open a valve on the steering engine and apply steam until pressure was equalised in the system. If you turned the wheel till the pointer on front of the pedestal was at 5 degrees then the steam tiller would operate until pressure in the lines was equalised and 5 degrees of helm was on.
On Titanic there was also an electrically operated helm indicator which sensed the rudder position and relayed this to an indicator on the bridge. The steering wheels on Olympic, Titanic and Britannic were duplicated, the wheel in the forward part of the bridge was only used in port and was connected by shafting to the main Telemotor control and wheel which was in the wheelhouse. The forward wheel could be disconnected by a clutch, which could only be engaged or disengaged when the helm was midships. There was a steering wheel with Telemotor control in docking bridge this was only for emergency use. The Waverley Clyde paddle steamer uses Browns Steam Steering gear and Telemotor.
Source: https://www.encyclopedia-titanica.org



Set a search alert
Set a search alert to get notified when new matches are available.

This object was featured in

                                        
                                                                                                    
                    
                                        
                                                                                                    
                    
                                        
                                                                                                    
                    

How to buy on Catawiki

Learn more about our Buyer Protection

      1. Discover something special

      Browse through thousands of special objects selected by experts. View the photos, details and estimated value of each special object. 

      2. Place the top bid

      Find something you love and place the top bid. You can follow the auction to the end or let our system do the bidding for you. All you have to do is set a bid for the maximum amount you want to pay. 

      3. Make a secure payment

      Pay for your special object and we’ll keep your payment secure until it arrives safe and sound. We use a trusted payment system to handle all transactions. 

Have something similar to sell?

Whether you're new to online auctions or sell professionally, we can help you earn more for your special objects.

Sell your object